The AK-RS232 is a TTL to RS232 adapter that converts TTL signals from a microcontroller UART (typically 3.3V or 5V) to RS232 signals like the ones you can find on a PC or MAC. Basically, this boards allows you to connect your microcontroller UART to a PC/MAC serial port.
This adapter can be used with any microcontroller (PIC, Atmel, ARM, ARM Cortex, Renesas, etc), and allows bidirectional communication: converts signals from TTL to RS232 and from RS232 to TTL. The AK-RS232 accepts power supply and TTL signals from 3.3V up to 5V.
The board is built around an ST3232B chip from STmicroelectronics, and drives all the signals you can typically find in a serial port. That is: RX/TX and CTS/RTS.
You can purchase it with a female or male DB9 connector, with or without the plastic case, by choosing the possible combinations in the drop-down menu here above. We also ship a TTL to RS232 converter breakout board without the DB9 connector.
The board comes fully populated and tested.
Note: for high-volume (+100) purchases please use the contact form for ordering and discounts.
| Weight | 0.010 kg |
|---|---|
| Dimensions | 20 × 30 × 10 mm |
| Connector | Male, Female |
| Casing | Without plastic case, With plastic case |
The AK-RS232 is a TTL (transistor-transistor logic) to RS232 converter that fits inside a standard DB9 plastic case. Based on the ST3232B chip from STmicroelectronics.
€5.80 – €6.80
Accepting all credit cards and wire transfers
Secure payments with Stripe and PayPal
Need help? Drop a line in our support forum.
Comments
You must be logged in to post a comment.
Hi, Is there anyway to disable (Hi-z) for TTL output?
Hi,
Does the converter support DTR signal? I just need that to be HIGH all the time. Thanks in advance.
Hello,
In this board the DTR pin is not connected. If you want to use the DTR you can use an AK-3232 (https://www.artekit.eu/products/breakout-boards/io/ak-3232-ttl-to-rs232-converter-breakout/) or AK-3232L (https://www.artekit.eu/products/breakout-boards/io/ak-3232l/).
Hello, To control audio processors, we need to convert a 3,3V ttl signal to RS232. There is only 24VDC available. Do you think it it possible to implement a voltage regulator (like the L78L33ACZ) in de db9 housing? What power (mW) is needed to supply the convertor?
Thanks in advance.
Hello Stephan,
That regulator should do the job. The board needs 1mA max.
Regarding putting it into a DB9 housing, the space is limited so I can’t tell how feasible it would be.
Hello,
Can I use this product to interface a vending machine with an RS232 port on the computer?
Hello, Norway calling.
I am trying to use this product to convert serial output from an Arduino (TTL) to serial port on PC (RS232), but I am not able to get any data to the serial port on the PC (or back to the Arduino for that matter). I have powered the converter with 5v as the Arduino, and shared ground with the Arduino. Baudrate Arduino is sending at is 57600, which is what the PC port is opened to (N81), no flow control. Serial output of Arduino is connected to Tx on converter. Any hints as to where I’m going wrong ?
Please ignore previous post then. I tried with another USB->RS232 converter and it works just fine! 🙂